Single head computer embroidery machine maintenance method

What are the items for keeping a single-head computerized embroidery machine? The computerized embroidery machine is placed in the courtyard, will it have any infringement on it? To this end, here is a list of things for everyone to pay attention to the maintenance of computer embroidery machines.

1. Single head embroidery machine should pay attention to physical conditions and electrical conditions. The factory with the same physical condition can be satisfied with the premise, not too boring or too humid, the temperature is 050 degrees Celsius, the absolute temperature is 30% 70%. Superior ventilation,

2. Electrical requirements for higher request voltage stability, it is best to install a transformer, the voltage is usually 380V or 220V, the foreign has adopted 110V, the power is usually 1.5KW to 2KW, the single-head computer embroidery machine is usually 500W ,

3. The current generated when the brake is turned on or off is much larger than that when it is stable. If the frequency switch still causes the temperature to rise too fast or the system is overloaded, the application life of the embroidery machine will be reduced. This should also be noted. The Double head embroidery machine is the most advanced equipment in the embroidery industry today. It inherits the ancient Chinese embroidery civilization. As a high-tech product, it also needs scientific management at the moment of support, shielding the operation of the machine and the complete machine, so that the ability to make the computer The embroidery machine is applied longer and better.

Embroidery mechanism version stitch length setting

Do not set the jump stitch when the pattern is finished, otherwise the towel ring will be hooked by the needle. When you start from the beginning of the towel embroidered pattern, you must take two or three stitches and then jump the needle. If the needle is jumped indirectly from the beginning of the towel, the embroidery thread will be taken up to spread the towel ring. The towel embroidery pattern is realized by two or three stitch chain stitches on weekdays. If the towel is stopped indirectly, the stitches will spread when the sewing material is exchanged. Prevent sharp changes in embroidery bias.

Otherwise, jumpers will occur. In addition, when the surrounding entangled rust and the upper belt embroidered, there will be a pile of wires to make the stitches rise, and the consequences are not beautiful. On weekdays, the bias is changed within 90°. The stitch length must be consistent when playing the plate. When the stitch length is inconsistent, the chain stitch will become unstable; the height of the towel stitch is also inconsistent. The length of the stitch length is set according to the thickness of the stitch applied, the thickness of the stitching, and the stitch density requested by the pattern. The length of the stitch length does not change in the uniform pattern. When it is necessary to jump the needle, some of the sewing material will be deformed by the beating. Therefore, the pattern should be as short as possible in any place (Note: Surround entangled embroidery and upper embroidery can not jump)
Article Source：https://www.embroiderymachinery.net/