Embroidery mechanism version stitch length setting

Do not set the jump stitch when the pattern is finished, otherwise the towel ring will be hooked by the needle. When you start from the beginning of the towel embroidered pattern, you must take two or three stitches and then jump the needle. If the needle is jumped indirectly from the beginning of the towel, the embroidery thread will be taken up to spread the towel ring. The towel embroidery pattern is realized by two or three stitch chain stitches on weekdays. If the towel is stopped indirectly, the stitches will spread when the sewing material is exchanged. Prevent sharp changes in embroidery bias.

Otherwise, jumpers will occur. In addition, when the surrounding entangled rust and the upper belt embroidered, there will be a pile of wires to make the stitches rise, and the consequences are not beautiful. On weekdays, the bias is changed within 90°. The stitch length must be consistent when playing the plate. When the stitch length is inconsistent, the chain stitch will become unstable; the height of the towel stitch is also inconsistent. The length of the stitch length is set according to the thickness of the stitch applied, the thickness of the stitching, and the stitch density requested by the pattern. The length of the stitch length does not change in the uniform pattern. When it is necessary to jump the needle, some of the sewing material will be deformed by the beating. Therefore, the pattern should be as short as possible in any place (Note: Surround entangled embroidery and upper embroidery can not jump)
Article Source：https://www.embroiderymachinery.net/